Translator Disclaimer
19 March 2008 Continuous process window modeling for process variation aware OPC and lithography verification
Author Affiliations +
Abstract
As the semiconductor industry moves to the 45nm node and beyond, the tolerable lithography process window significantly shrinks due to the combined use of high NA and low k1 factor. This is exacerbated by the fact that the usable depth of focus at 45nm node for critical layer is 200nm or less. Traditional Optical Proximity Correction (OPC) only computes the optimal pattern layout to optimize its patterning at nominal process condition (nominal defocus and nominal exposure dose) according to an OPC model calibrated at this nominal condition, and this may put the post-OPC layout at nonnegligible patterning risk due to the inevitable process variation (defocus and dose variations). With a little sacrifice at the nominal condition, process variation aware OPC can greatly enhance the robustness of post-OPC layout patterning in the presence of defocus and dose variation. There is also an increasing demand for through process window lithography verification for post-OPC circuit layout. The corner stone for successful process variation aware OPC and lithography verification is an accurately calibrated continuous process window model which is a continuous function of defocus and dose. This calibrated model needs to be able to interpolate and extrapolate in the usable process window. Based on Synopsys' OPC modeling software package ProGen, we developed and implemented a novel methodology for continuous process window (PW) model, which has two continuous adjustable process parameters: defocus and dose. The calibration of this continuous PW model was performed in a single calibration process using silicon measurement at nominal condition and off-focus-off-dose conditions which are sparsely sampled within the measured entire focus exposure matrix (FEM). The silicon data at the off-focus-off-dose conditions not used for model calibration was utilized to validate the accuracy and stability of PW model during model interpolation and extrapolation. We demonstrated this novel continuous PW modeling approach can achieve very good performance both at nominal condition and at interpolated or extrapolated off-focus-off-dose conditions.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Qiaolin Zhang, Qiliang Yan, Yunqiang Zhang, and Kevin Lucas "Continuous process window modeling for process variation aware OPC and lithography verification", Proc. SPIE 6925, Design for Manufacturability through Design-Process Integration II, 69251A (19 March 2008); doi: 10.1117/12.772737; https://doi.org/10.1117/12.772737
PROCEEDINGS
10 PAGES


SHARE
Advertisement
Advertisement
Back to Top