Translator Disclaimer
22 July 2008 The design of EUV CCD camera
Author Affiliations +
This paper describes the design of CCD camera that is part of the EUV detector to be used in Space Solar Telescope. It will run at the solar synchronous circular orbit with 735 km height. In this paper, a CCD camera is designed composed of the CCD sensor module, the analog system and the embedded controller with an NIOSII soft-core processor based on FPGA. The analog system is first introduced in detail including power and bias voltage supply circuit, 16 bit A/D converter, power protecting circuit, amplifier circuit, and CCD driving clocks generation circuit. NIOS II embedded system is then presented including system hardware and NIOS II processor. Finally, evaluation results of this camera are also presented including readout noise, gain, linearity, dynamic range and full well capacity.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yuanyuan Shang, Yong Guan, Yingfei Liu, and Xiaoxu Zhao "The design of EUV CCD camera", Proc. SPIE 7021, High Energy, Optical, and Infrared Detectors for Astronomy III, 70211O (22 July 2008);


CCD imaging system for the EUV solar telescope
Proceedings of SPIE (February 01 2006)
Image data acquisition system for large-format CCDs
Proceedings of SPIE (May 31 1994)
2M pixels FIT CCD with Hyper HAD sensor and camera...
Proceedings of SPIE (August 11 1992)
Low noise CCD cameras for wide field astronomy
Proceedings of SPIE (April 25 2006)

Back to Top