17 October 2008 Improvements in accuracy of dense OPC models
Author Affiliations +
Abstract
Performing model-based optical proximity correction (MBOPC) on layouts has become an integral part of patterning advanced integrated circuits. Earlier technologies used sparse OPC, the run times of which explode when the density of layouts increases. With the move to 45 nm technology node, this increase in run time has resulted in a shift to dense simulation OPC, which is pixel-based. The dense approach becomes more efficient at 45nm technology node and beyond. New OPC model forms can be used with the dense simulation OPC engine, providing the greater accuracy required by smaller technology nodes. Parameters in the optical model have to be optimized to achieve the required accuracy. Dense OPC uses a resist model with a different set of parameters than sparse OPC. The default search ranges used in the optimization of these resist parameters do not always result in the best accuracy. However, it is possible to improve the accuracy of the resist models by understanding the restrictions placed on the search ranges of the physical parameters during optimization. This paper will present results showing the correlation between accuracy of the models and some of these optical and resist parameters. The results will show that better optimization can improve the model fitness of features in both the calibration and verification set.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Chidam Kallingal, James Oberschmidt, Ramya Viswanathan, Amr Abdo, OSeo Park, "Improvements in accuracy of dense OPC models", Proc. SPIE 7122, Photomask Technology 2008, 71221Q (17 October 2008); doi: 10.1117/12.801695; https://doi.org/10.1117/12.801695
PROCEEDINGS
12 PAGES


SHARE
Back to Top