Translator Disclaimer
12 January 2009 Modification and prototype test of staple gun
Author Affiliations +
Proceedings Volume 7133, Fifth International Symposium on Instrumentation Science and Technology; 71330Q (2009) https://doi.org/10.1117/12.812085
Event: International Symposium on Instrumentation Science and Technology, 2008, Shenyang, China
Abstract
This paper presents how to design a staple gun and verify its data through simulation. The staple gun was estimated and analyzed using 'ANSYS' software and the results were compared with those obtained through experiments. In this research, a supporting position for the spring inside the staple gun was damaged after hundreds of loads, and there was no data about the impact force when staples were shot into the targets. Therefore, a prototype test system is developed to validate the data through simulation. In this case, the results are quite close to each other before they can be used to help the manufacturer to improve its structure. This prototype test system is completed through PC-based automation software. The simulation model was modified to develop the next new products for saving costs and time. Because the impact force, coming out from the staple gun is pretty large, it should be restricted within a certain limit to keep the user safe.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kuang-Yih Tsue and Gwo-Jen Wu "Modification and prototype test of staple gun", Proc. SPIE 7133, Fifth International Symposium on Instrumentation Science and Technology, 71330Q (12 January 2009); https://doi.org/10.1117/12.812085
PROCEEDINGS
5 PAGES


SHARE
Advertisement
Advertisement
Back to Top