16 March 2009 Novel OPC method to create sub 45nm contact hole using design based metrology
Author Affiliations +
Abstract
During the past few years, new technology brought about new problems we face today due to shrinkage of the feature size. Some of the problems such as Mask Error Enhancement Factor (MEEF), overlay control, and so on are crucial because large MEEF can make it difficult to satisfy CD target, and bring about large CD variation. Moreover, it can also lead to degraded CD uniformity which would have an undesired influence on device properties. Recently, 2-D random contact hole is getting crucial because it normally has very large MEEF and cause asymmetric proximity effect which can cause large CD variation, and misalignment of layer-to-layer. In other words, the method of optical proximity correction and building accurate OPC model for 2-D random contact hole pattern could be key factor obtaining better CD uniformity with enhanced overlay margin. Furthermore, in order to get very tangible performance, design based metrology system (DBM) is used to evaluate process performance. Design based metrology systems are able to extract information of whole chip CD variation. On top of that, OPC abnormality can be identified and design feedback can be also disclosed. In this paper, we will investigate novel method for sub 45nm 2-D random contact hole printing. First, optical proximity effect (OPE) for two dimensional layout will be investigated. Second, the results of Variable Threshold Modeling (VTM) for various slit contact hole patterns will be analyzed. Third, model based verification will be done and analyzed through full-chip before creating full-chip mask. Finally, sub 45nm 2-D random contact hole printing performance will be presented by DBM.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Dong-Jin Lee, Dong-Jin Lee, Se-young Oh, Se-young Oh, Jong-cheon Park, Jong-cheon Park, Jin-young Choi, Jin-young Choi, Jungchan Kim, Jungchan Kim, Cheolkyun Kim, Cheolkyun Kim, Donggyu Yim, Donggyu Yim, } "Novel OPC method to create sub 45nm contact hole using design based metrology", Proc. SPIE 7274, Optical Microlithography XXII, 72742C (16 March 2009); doi: 10.1117/12.814386; https://doi.org/10.1117/12.814386
PROCEEDINGS
9 PAGES


SHARE
RELATED CONTENT

Rotation-induced measurement error by a CD-SEM
Proceedings of SPIE (June 01 2003)
Development methods for chemical amplification resist
Proceedings of SPIE (August 31 1998)
Advanced mask and reticle generation using EBES4
Proceedings of SPIE (December 06 1994)
SEM-based system for photomask placement metrology
Proceedings of SPIE (May 13 2007)

Back to Top