Translator Disclaimer
Paper
7 January 2009 Material removal by the electrical microdischarges
Author Affiliations +
Proceedings Volume 7297, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies IV; 72970R (2009) https://doi.org/10.1117/12.823637
Event: Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies IV, 2008, Constanta, Romania
Abstract
In the case of the electrical discharge machining, the obtained surface is a concatenation of craters generated by the electrical discharges. The dimensions of the crater generated by a single electrical discharge could offer an image concerning the material behavior during the electrical discharge machining and the phenomena corresponding to this machining technique. To ensure better conditions for the experiments development, a research schema based on the initiation of the single electrical discharge between the rectilinear edges of two parallelipiedic bars placed in plans perpendicular each other was applied. A factorial experiment with two independent variables at two levels was used to establish an empirical relation type power; the relation emphasizes the influence exerted by the voltage and by the capacity of the relaxation circuit on the dimensions of the crater. The sizes of the exponents proves the bigger influence exerted by the input factors on the crater width.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Laurentiu Slătineanu, Margareta Coteaţă, Oana Dodun, Dan Anton, and Adrian Iosub "Material removal by the electrical microdischarges", Proc. SPIE 7297, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies IV, 72970R (7 January 2009); https://doi.org/10.1117/12.823637
PROCEEDINGS
5 PAGES


SHARE
Advertisement
Advertisement
Back to Top