24 August 2009 On the formability, geometrical accuracy, and surface quality of sheet metal parts produced by SPIF
Author Affiliations +
Proceedings Volume 7375, ICEM 2008: International Conference on Experimental Mechanics 2008; 73750N (2009) https://doi.org/10.1117/12.839028
Event: International Conference on Experimental Mechanics 2008 and Seventh Asian Conference on Experimental Mechanics, 2008, Nanjing, China
Abstract
Conventional sheet metal forming processes are not suitable for flexible small-batch production and, therefore, are not appropriate for the growing agile manufacturing trends requiring very short life-cycles, development and production lead times. In fact, the present need for flexible sheet metal forming techniques requires the development of innovative technological solutions that are capable of reducing the fixed and capital costs of sheet metal forming to a level where small-batch production becomes economically feasible. Single point incremental forming (SPIF) is a new sheet metal forming process with a high potential economic payoff for rapid prototyping applications and for small quantity production. In general terms a typical SPIF set-up makes use of a small number of low cost active tools components; (i) a blankholder, (ii) a backing plate and (iii) a single point forming tool. The tool path is generated in a CNC machining center and during the process there is no backup die supporting the back surface of the sheet. Despite the contributions of many researchers on the development of industrial applications and better characterization of the forming limits of the process, several key topics related to the mechanics of deformation, likely mode of failure, geometric accuracy and surface quality of the formed parts remain little understood and scarcely systematized. This paper attempts to provide new contributions about the abovementioned issues by means of a comprehensive experimental investigation performed under laboratory controlled conditions.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
M. L. Alves, M. L. Alves, M. B. Silva, M. B. Silva, L. M. Alves, L. M. Alves, P. A. F. Martins, P. A. F. Martins, } "On the formability, geometrical accuracy, and surface quality of sheet metal parts produced by SPIF", Proc. SPIE 7375, ICEM 2008: International Conference on Experimental Mechanics 2008, 73750N (24 August 2009); doi: 10.1117/12.839028; https://doi.org/10.1117/12.839028
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT

Study on mild and severe wear of 7075 aluminum alloys...
Proceedings of SPIE (January 23 2017)
New decade of shaped beryllium blanks
Proceedings of SPIE (September 02 2015)
38% Aluminum - 62% Beryllium shaped blank technology
Proceedings of SPIE (September 17 2007)
Mechanical behavior of soil and concrete interface
Proceedings of SPIE (August 25 2009)
Surface texture characterization using a chroma meter
Proceedings of SPIE (February 17 2003)

Back to Top