5 August 2009 Research of thermal cycles of long wavelength MCT infrared detectors
Author Affiliations +
Proceedings Volume 7383, International Symposium on Photoelectronic Detection and Imaging 2009: Advances in Infrared Imaging and Applications; 73831A (2009); doi: 10.1117/12.835864
Event: International Symposium on Photoelectronic Detection and Imaging 2009, 2009, Beijing, China
Abstract
The conflict of longevity of satellite's service and limited life of Sterling cooler decides that coolers should work on the intermittent mode in space. As a result, The HgCdTe (MCT) infrared (IR) detectors in satellite are commonly subjected to thousands of repeated thermal cycles from below -173°C to room temperature (20°C), which brings some new reliability problems. Especially the mismatch of coefficient of thermal expansion (CTE) of different materials may lead to some unfamiliar failure modes with such low temperature and nearly 200°C span of thermal cycles. In order to study the characteristics of MCT detectors under the stress of thermal cycles, this paper introduced a special automatic system. The system is mainly composed of a sub-container of liquid nitrogen, a heater controlled by the PID hardware, and an object stage on which the MCT detectors to be tested are mounted. Furthermore, the sub-container, the heater and the stage are positioned in a large vacuum tank. In the course of thermal cycles, the object stage moved up and down with MCT detectors is driven by a step motor. When it rises to the bottom of liquid nitrogen sub-container, the stage is to be cooled with detectors, and when declines to the heater, the stage to be heated with detectors, too. At last, two long wavelength MCT detector samples are tested with this equipment, and the resistance, the signal and the noise are measured. It shows that all the pixels' resistance didn't change beyond 5% after 5000 cycles. However, the tested signal of the last pixel of both detectors increased sharply after 1000 cycles, and fell to normal level after 5000 cycles, with its noise altering a little from beginning to end. A deduction is given in this paper for this phenomenon. In accordance, the thermal cycle equipment and the experimental data, would supply some references to the design and fabrication of MCT IR detectors.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Li-gang Wu, Da-fu Liu, San-gen Zhu, Hai-mei Gong, "Research of thermal cycles of long wavelength MCT infrared detectors", Proc. SPIE 7383, International Symposium on Photoelectronic Detection and Imaging 2009: Advances in Infrared Imaging and Applications, 73831A (5 August 2009); doi: 10.1117/12.835864; https://doi.org/10.1117/12.835864
PROCEEDINGS
6 PAGES


SHARE
KEYWORDS
Sensors

Infrared detectors

Resistance

Signal detection

Liquids

Nitrogen

Interference (communication)

RELATED CONTENT


Back to Top