21 August 2009 Spectral features: how to reduce them
Author Affiliations +
Abstract
Spectral features are introduced by the diffuser that is used during on-board sun calibration. New findings are presented on how to reduce the size of these spectral features. Reduction can be obtained via optical design of the calibration unit, but also in creating a better diffuser. A novel diffuser design will be presented and its performance will be compared to standard diffusers like an Aluminum diffuser, a Spectralon diffuser, and the QVD (Quasi Volume Diffuser). For the in-house spectral features testing setup an improvement of about a factor of eight was obtained for the new diffuser type when compared to QVD. QVD in its turn is already better than an Aluminum diffuser by a factor of ten. Spectralon and QVD are found to be about equally good when measured in terms of spectral features reduction. The novel diffuser is referred to as SanDiff since it is a sandwich of QVD and PTFE material. For the SanDiff also the BSDF was measured and will be presented here.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hedser van Brug, Daniel ten Bloemendal, Bryan de Goeij, Ramon Vink, Luca Maresi, "Spectral features: how to reduce them", Proc. SPIE 7452, Earth Observing Systems XIV, 745203 (21 August 2009); doi: 10.1117/12.822957; https://doi.org/10.1117/12.822957
PROCEEDINGS
8 PAGES


SHARE
RELATED CONTENT

Spectral features: an overview
Proceedings of SPIE (October 06 2011)
The effect of speckle on BRDF measurements
Proceedings of SPIE (August 22 2005)
Spectral features, effects, and cures
Proceedings of SPIE (October 05 2007)
Spectral features due to on-board diffusers
Proceedings of SPIE (August 22 2005)

Back to Top