17 September 2009 Dusty plasmas for on-site spectroscopic analysis of water sources
Author Affiliations +
This paper reports on a low-cost, borosilicate glass-based spectroscopic sensor for the detection of water contaminants. 10 μL water samples are inserted into a sandblasted sample reservoir in a borosilicate glass substrate and are partially evaporated with a 200 nm thin-film Cr microheater/cathode patterned to the bottom of the reservoir. The relative contaminant concentration within the partially evaporated sample is greater, providing a means of measuring lower concentrations of impurities. An on-chip plasma discharge is stuck to the sample, sputtering the water contaminants into the discharge, doping its spectral emissions. Cu and Fe impurities are detected at 10 ppm in a 2.5% HNO3 solution and Ca and Mg contaminants are detected at 100 ppm. The on-chip microheater yields temperature changes as high as 96 °C when supplied with 100 mA. Multiple single-use sensors can be fabricated inexpensively on the borosilicate glass substrate using simple, standard photolithography techniques.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
John Sweeney, John Sweeney, Chester G. Wilson, Chester G. Wilson, } "Dusty plasmas for on-site spectroscopic analysis of water sources", Proc. SPIE 7484, Optically Based Biological and Chemical Detection for Defence V, 748404 (17 September 2009); doi: 10.1117/12.830110; https://doi.org/10.1117/12.830110

Back to Top