20 November 2009 Single-image based dimensions inspection technology for planar industrial parts
Author Affiliations +
Abstract
The industrial parts' dimensions are the important characteristics for their eligibility evaluation; typically, the multiple cameras system is the preferred technology that fitting the inspection, especially for on-line testing, but the cameras calibration, images matching, etc. are necessary when put in practice, also, multiple cameras system is either too costly or impractical sometimes. A novel dimensions inspection technology based on single-image for planar industrial parts is presented. The technology described here uses single-image taken by a camera in arbitrary pose, and requires four scale-bars with known distances sticking on the planar industrial part, the four known distances are used to correct the single-image to normal, and the part's dimensions are obtained by triangulation comparability from the normal image. The utilities of this method are its low-cost, simplicity, ease of implementation and camera calibration needless. The technology is being used in the real-time inspection of precision machining for the evaporator tubes plate of nuclear boiler, applications show that the method is effective, and the typical dimensions accuracy is 0.05 mms if the testing range is about 0.5ms by 0.5ms per-time.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ji-hua Chen, Ji-hua Chen, Yan-yun Jiang, Yan-yun Jiang, } "Single-image based dimensions inspection technology for planar industrial parts", Proc. SPIE 7511, 2009 International Conference on Optical Instruments and Technology: Optoelectronic Measurement Technology and Systems, 751115 (20 November 2009); doi: 10.1117/12.837650; https://doi.org/10.1117/12.837650
PROCEEDINGS
10 PAGES


SHARE
Back to Top