Fabrication of micro-lenses using excimer laser ablation by means of laser-generated grey-tone-masks

T. Klotzbuecher; D. Dadic

doi:10.1117/12.845476

23 February 2010 Fabrication of micro-lenses using excimer laser ablation by means of laser-generated grey-tone-masks

T. Klotzbuecher, D. Dadic

Proceedings Volume 7585, Laser-based Micro- and Nanopackaging and Assembly IV; 75850C (2010) https://doi.org/10.1117/12.845476
Event: SPIE LASE, 2010, San Francisco, California, United States

Abstract

Micro-lenses, including Fresnel-Lenses, were fabricated by excimer laser ablation of polymers by means of lasergenerated grey-tone-masks. The smallest reproducible holes that could be fabricated by excimer laser ablation (193 nm, 1 J/cm²) of chromium-on-quartz (thickness 50-100 nm) were around 3 μm, the pitch of which should be at least at the same value to ensure a reproducibility of hole-arrays. To achieve acceptable ablation times during the fabrication of the grey-tone-masks, on-the-fly ablation instead of step-and-repeat technique was used, operating the laser at a constant pulse repetition rate <30 Hz with a continuously moving quartz-substrate. In this way and using different encoding techniques it was possible to generate at least 11 different grey-tones. The available grey-tones were used to generate grey-tone-masks for ablation of Polymethylmethacrylate (PMMA) and Polycarbonate (PC). For that, fluences in the range of 0.07-0.14 J/cm² could be applied, corresponding to a value of 1.25 J/cm² on the workpiece without grey-tonemask and a value lying well below the damage threshold of the chromium mask. Refractive micro-lenses fabricated in this way did not show a good imaging quality, since 11 grey-tones is less than required to generate a continuous surface profile over the full diameter of the lens during ablation and the achievable aspect ratio is limited with the small fluences. However, flat diffractive micro-lenses of the Fresenel type with a quasi-continuously surface profile could be fabricated in a sufficient manner. This can be attributed to the fact that each segment of the Fresenel-lenses can be encoded by 11 grey-tones, leading to much smoother surface reliefs and to a sufficient imaging quality.

Citation Download Citation

T. Klotzbuecher and D. Dadic "Fabrication of micro-lenses using excimer laser ablation by means of laser-generated grey-tone-masks", Proc. SPIE 7585, Laser-based Micro- and Nanopackaging and Assembly IV, 75850C (23 February 2010); https://doi.org/10.1117/12.845476

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available