29 March 2010 Methods to explore and prevent pattern collapse in thin film lithography
Author Affiliations +
Abstract
Pattern collapse is becoming a critical issue as integrated circuit fabrication continues to advance towards the 32 nm node and below. Though line edge roughness and resolution are certainly important in moving forward, pattern collapse by both deformation and adhesion failure must be addressed. In this work, a post-development strategy to reduce pattern collapse by bending was developed whereby the hydroxyl functional groups on the surface of the resist were crosslinked via a dicarboxylic acid using carbodiimide chemistry. The pattern collapse of a hydroxystyrene-based, positive tone resist was then studied before and after the application of the reactive rinse. SEM analysis of the samples showed that application of the reactive rinse resulted in a clear increase in the printing capabilities of the resist, as the photoresist lines could be printed with smaller space widths corresponding to higher stresses after the rinse treatment.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
David E. Noga, David E. Noga, Wei-Ming Yeh, Wei-Ming Yeh, Richard A. Lawson, Richard A. Lawson, Laren M. Tolbert, Laren M. Tolbert, Clifford L. Henderson, Clifford L. Henderson, } "Methods to explore and prevent pattern collapse in thin film lithography", Proc. SPIE 7639, Advances in Resist Materials and Processing Technology XXVII, 76392O (29 March 2010); doi: 10.1117/12.848423; https://doi.org/10.1117/12.848423
PROCEEDINGS
6 PAGES


SHARE
Back to Top