Flexible enhanced energy density composites for dielectric elastomer actuators

H. Stoyanov; M. Kollosche; D. N. McCarthy; S. Risse; A. Becker; H. Ragusch; G. Kofod

doi:10.1117/12.847861

9 April 2010 Flexible enhanced energy density composites for dielectric elastomer actuators

H. Stoyanov, M. Kollosche, D. N. McCarthy, S. Risse, A. Becker, H. Ragusch, G. Kofod

Proceedings Volume 7642, Electroactive Polymer Actuators and Devices (EAPAD) 2010; 76422G (2010) https://doi.org/10.1117/12.847861
Event: SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring, 2010, San Diego, California, United States

Abstract

Dielectric elastomer actuators deform due to voltage-induced Maxwell-stress, which interacts with the mechanical properties of the material. Such actuators are considered for many potential applications where high actuation strain and moderate energy density comparable to biological muscle are required. However, the high voltage commonly required to drive them is a limitation, especially for biomedical applications. The high driving voltage can be lowered by developing materials with increased permittivity, while leaving the mechanical properties unaffected. Here, an approach to lowering the driving voltage is presented, which relies on a grafted nano-composite, in which conducting nanoparticles are integrated directly into a flexible matrix by chemical grafting. The conducting particles are π-conjugated soft macromolecules, which are grafted chemically to a polymer matrix flexible backbone. Dielectric spectroscopy, tensile mechanical analysis, and electrical breakdown strength tests were performed to fully characterize the electro-mechanical properties. Planar actuators were prepared from the resulting composites and actuation properties were tested in two different modes: constant force and constant strain. With this approach, it was found that the mechanical properties of the composites were mostly unaffected by the amount of nanoparticles, while the permittivity was seen to increase from 2.0 to 15, before percolation made further concentration increases impossible. Hence, it could be demonstrated that the socalled "optimum load" was independent from the permittivity (as expected), while the operating voltage could be lowered, or higher strains could be observed at the same voltage.

Citation Download Citation

H. Stoyanov, M. Kollosche, D. N. McCarthy, S. Risse, A. Becker, H. Ragusch, and G. Kofod "Flexible enhanced energy density composites for dielectric elastomer actuators", Proc. SPIE 7642, Electroactive Polymer Actuators and Devices (EAPAD) 2010, 76422G (9 April 2010); https://doi.org/10.1117/12.847861

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available

Members: $17.00

Non-members: $21.00 ADD TO CART

PROCEEDINGS
7 PAGES

DOWNLOAD PAPER SAVE TO MY LIBRARY

GET CITATION

RIGHTS & PERMISSIONS

Get copyright permission Get copyright permission on Copyright Marketplace

KEYWORDS

Composites

Polymers

Dielectrics

Actuators

Electrical breakdown

Dielectric elastomer actuators

Macromolecules

Show All Keywords

Keywords/Phrases

Search In:

Publication Years