Translator Disclaimer
31 March 2010 Detection and assessment of wood decay in glulam beams using a decay rate approach
Author Affiliations +
Abstract
A glulam beam retired from the field and without visible indications of wood decay was used. Towards detection and assessing wood decay, X-ray computer tomography and ultrasonic measurements were carried out. It was observed that decrease in mass density with increasing levels of wood decay affects x-rays attenuation and allows radioscopy to detect and assess wood decay. To detect and assess decay when only one lateral side of the beam is available, a modified impulse-echo is presented. The modified impulse-echo approach is based on observing the dynamic response of each lamina in the glulam beam to the drop of a steel sphere onto a steel plate coupled to the glulam beam lamina and upon a decay rate analysis of the corresponding time domain signal in a frequency band of interest. The selection of the frequency band of interest only requires knowledge of the nominal transverse dimensions of each lamina in the beam and of the corresponding wood species. It was observed that decay rate analysis allows detection and assessment of wood decay. The decay rate approach leads to an overall rate of false calls of 7.2%. Considering the variability that exists in wood including the presence of splits, orientation and thickness of growth rings, etc., this relative low rate of false calls makes this approach very attractive. Results show that results from both X-ray computer tomography and impulse-echo decay-rated based measurements are consistent with each other and can be used to detect and assess wood decay in structural lumber.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Adam Senalik, Frank C. Beall, and Henrique Reis "Detection and assessment of wood decay in glulam beams using a decay rate approach", Proc. SPIE 7647, Sensors and Smart Structures Technologies for Civil, Mechanical, and Aerospace Systems 2010, 76471L (31 March 2010); https://doi.org/10.1117/12.843603
PROCEEDINGS
12 PAGES


SHARE
Advertisement
Advertisement
Back to Top