Design, simulation, and fabrication of a 90° SOI optical hybrid based on the self-imaging principle

Sawsan Abdul-Majid; Imad I. Hasan; Przemek J. Bock; Trevor J. Hall

doi:10.1117/12.854735

17 May 2010 Design, simulation, and fabrication of a 90° SOI optical hybrid based on the self-imaging principle

Sawsan Abdul-Majid, Imad I. Hasan, Przemek J. Bock, Trevor J. Hall

Proceedings Volume 7719, Silicon Photonics and Photonic Integrated Circuits II; 77190E (2010) https://doi.org/10.1117/12.854735
Event: SPIE Photonics Europe, 2010, Brussels, Belgium

Abstract

This paper introduces a compact 90º optical hybrid, built on small size SOI waveguide technology .This optical hybrid is a critical component of a potentially low-cost coherent optical receiver design developed within the frame of our Optical Coherent Transmission for Access Network Extensions (OCTANE) project. In previous recent work, 90º optical hybrids were realized in SOI rib waveguide technology with 4 μm top silicon and a rib height of approximately 2 μm. In this paper, we introduce a compact 90º optical hybrid, built on small size SOI waveguide technology (1.5 μm SOI -based rib waveguide, with 0.8μm rib height). The proposed device consists of multimode interferometers (MMIs) connected in such a way that four different vector additions of a reference signal (local oscillator) and the signal to be detected are obtained. At the outputs, the hybrid provides four linear combination of the signal with the reference which differs by a relative phase shift of the reference of 90º. The four output signals are detected by a pair of balanced receivers to provide in-phase and quadrature (I&Q) channels. The phase differences arise naturally from the self imaging property of a MMI. The key elements of the 90º optical hybrid, including a 2×2 MMI, a 4×4 MMI, and polarization diversity configuration have been designed and simulated, using the numerical mode solving tool FIMMPROB. The 2×2 and 4×4 MMI had overall lengths of 701μm and 3712.5μm lengths respectively. Tapers are used to couple adiabatically single mode waveguides to the entrance and exit ports of the MMI to assure correct operation by avoiding coupling to the higher order transverse modes allowed at the entrance and exit ports of the MMI. The simulation results at 1550nm show polarization independence and phase errors between the ports of less than 0.03 degrees. Currently the design is in fabrication at the Canadian Photonics Fabrication Center with the support of CMC Microsystems and experimental results will be subject to a further report.

Citation Download Citation

Sawsan Abdul-Majid, Imad I. Hasan, Przemek J. Bock, and Trevor J. Hall "Design, simulation, and fabrication of a 90° SOI optical hybrid based on the self-imaging principle", Proc. SPIE 7719, Silicon Photonics and Photonic Integrated Circuits II, 77190E (17 May 2010); https://doi.org/10.1117/12.854735

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available