21 July 2010 The LINC-NIRVANA fringe and flexure tracker: control design overview
Author Affiliations +
The Fringe and Flexure Tracker System (FFTS) of the LINC-NIRVANA instrument is designed to monitor and correct the atmospheric piston variations and the instrumental vibrations and flexure at the LBT during the NIR interferometric image acquisition. In this contribution, we give an overview of the current FFTS control design, the various subsystems, and their interaction details. The control algorithms are implemented on a realtime computer system with interfaces to the fringe and flexure detector read-out electronics, the OPD vibration monitoring system (OVMS) based on accelerometric sensors at the telescope structure, the piezo-electric actuator for piston compensation, and the AO systems for offloading purposes. The FFTS computer combines data from different sensors with varying sampling rate, noise and delay. This done on the basis of the vibration data and the expected power spectrum of atmospheric conditions. Flexure effects are then separated from OPD signals and the optimal correcting variables are computed and distributed to the actuators. The goal is a 120 nm precision of the correction at a bandwidth of about 50 Hz. An end-to-end simulation including models of atmospheric effects, actuator dynamics, sensor effects, and on-site vibration measurements is used to optimize controllers and filters and to pre-estimate the performance under different observation conditions.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Steffen Rost, Steffen Rost, Andreas Eckart, Andreas Eckart, Matthew Horrobin, Matthew Horrobin, Bettina Lindhorst, Bettina Lindhorst, Uwe Lindhorst, Uwe Lindhorst, Lydia Moser, Lydia Moser, Semir Smajic, Semir Smajic, Christian Straubmeier, Christian Straubmeier, Evangelia Tremou, Evangelia Tremou, Imke Wank, Imke Wank, Jens Zuther, Jens Zuther, Thomas Bertram, Thomas Bertram, } "The LINC-NIRVANA fringe and flexure tracker: control design overview", Proc. SPIE 7734, Optical and Infrared Interferometry II, 77341V (21 July 2010); doi: 10.1117/12.857071; https://doi.org/10.1117/12.857071


The ELT control system
Proceedings of SPIE (July 06 2018)
Integrated modeling of the Euro50
Proceedings of SPIE (July 07 2004)
Modular concept for ELT adaptive optics
Proceedings of SPIE (February 04 2002)
Adaptive optics: choices and optimization
Proceedings of SPIE (August 25 1993)

Back to Top