Translator Disclaimer
Paper
5 April 2011 EUV flare and proximity modeling and model-based correction
Author Affiliations +
Abstract
The introduction of EUV lithography into the semiconductor fabrication process will enable a continuation of Moore's law below the 22 nm technology node. EUV lithography will, however, introduce new and unwanted sources of patterning distortions which must be accurately modeled and corrected on the reticle. Flare caused by scattered light in the projection optics is expected to result in several nanometers of on-wafer dimensional variation, if left uncorrected. Previous work by the authors has focused on combinations of model-based and rules-based approaches to modeling and correction of flare in EUV lithography. Current work to be presented here focuses on the development of an all model-based approach to compensation of both flare and proximity effects in EUV lithography. The advantages of such an approach in terms of both model and OPC accuracy will be discussed. In addition, the authors will discuss the benefits and tradeoffs associated with hybrid OPC approaches which mix both rules-based and modelbased OPC. The tradeoffs to be explored include correction time, accuracy, and data volume.
© (2011) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Christian Zuniga, Mohamed Habib, James Word, Gian F. Lorusso, Eric Hendrickx, Burak Baylav, Raghu Chalasani, and Michael Lam "EUV flare and proximity modeling and model-based correction", Proc. SPIE 7969, Extreme Ultraviolet (EUV) Lithography II, 79690T (5 April 2011); https://doi.org/10.1117/12.879488
PROCEEDINGS
13 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

EUV OPC modeling and correction requirements
Proceedings of SPIE (March 18 2014)
Evaluation of methods to improve EUV OPC model accuracy
Proceedings of SPIE (April 01 2013)
OPC model building for EUV lithography
Proceedings of SPIE (September 26 2019)
Accurate models for EUV lithography
Proceedings of SPIE (September 23 2009)
OPC modeling and correction solutions for EUV lithography
Proceedings of SPIE (October 13 2011)

Back to Top