PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
This study seeks to establish microforming technologies for complex-shaped micro-parts which require multi-axial flow
of material. For this purpose, it is important to develop new methods to fabricate micro-moulds and to select suitable
materials and processing technology for microforming. 4Cr5MoSiV1 has been used to fabricate micro-moulds and
Zr65Cu15Ni10Al10 bulk metallic glass has been employed in micro backward extrusion. Our research has demonstrated: (1)
The die mounting base which inner trapezoidal holes has been used instead of the conventional mould would reduce the
mould weight and simplify the processing technology. (2) The Zr65Cu15Ni10Al10 BMG flow strain rate decreases
significantly with punch diameter and punch speed decreasing in the supercooled liquid region, but low strain rate
resulting the extended processing time will cause crystallization phenomenon. (3) Excellent extruding results were
obtained under the punch speed of 8×10-3 mm/s at 703 K, the maximum punch load of 1200 N, the punch size of &nullset; 1.0mm and no pressure holding time.
Rong Cheng,Xiao Wu,Jianjun Li, andZhizhen Zheng
"Superplastic micro backward extrusion of Zr65 based bulk metallic glass for microparts", Proc. SPIE 7997, Fourth International Seminar on Modern Cutting and Measurement Engineering, 799714 (24 May 2011); https://doi.org/10.1117/12.884406
ACCESS THE FULL ARTICLE
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
The alert did not successfully save. Please try again later.
Rong Cheng, Xiao Wu, Jianjun Li, Zhizhen Zheng, "Superplastic micro backward extrusion of Zr65 based bulk metallic glass for microparts," Proc. SPIE 7997, Fourth International Seminar on Modern Cutting and Measurement Engineering, 799714 (24 May 2011); https://doi.org/10.1117/12.884406