Paper
3 October 2011 Investigation of the optical property and structure of WO3 thin films with different sputtering depositions
Author Affiliations +
Abstract
The purpose of this research was to compare the optical properties and structure of tungsten oxide (WO3) thin films that was deposited by different sputtering depositions. WO3 thin films deposited by two different depositions of direct current (DC) magnetron sputtering and pulsed DC sputtering. A 99.95% WO3 target was used as the starting material for these depositions. These WO3 thin films were deposited on the ITO glass, PET and silicon substrate by different ratios of oxygen and argon. A shadow moiré interferometer would be introduced to measure the residual stress for PET substrate. RF magnetron sputtering had the large residual stress than the other's depositions. A Raman spectrum could exhibit the phase of oxidation of WO3 thin film by different depositions. At the ratio of oxygen and argon was about 1:1, and the WO3 thin films had the best oxidation. However, it was important at the change of the transmittance (ΔT = Tbleached - Tcolored) between the coloring and bleaching for the smart window. Therefore, we also found the WO3 thin films had the large variation of transmittance between the coloring and bleaching at the gas ratios of oxygen and argon of 1:1.
© (2011) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hsi-Chao Chen, Der-Jun Jan, Chien-Han Chen, Kuo-Ting Huang, Yen-Ming Lo, and Sheng-Hui Chen "Investigation of the optical property and structure of WO3 thin films with different sputtering depositions", Proc. SPIE 8168, Advances in Optical Thin Films IV, 81681Z (3 October 2011); https://doi.org/10.1117/12.897017
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Thin films

Sputter deposition

Oxygen

Oxides

Raman spectroscopy

Tungsten

Thin film deposition

Back to Top