8 February 2012 Progress in increasing the maximum achievable output power of broad area diode lasers
Author Affiliations +
Abstract
High power broad area diode lasers provide the optical energy for all high performance laser systems, either directly or as pump sources for solid-state lasers. Continuous improvement is required in the peak achievable output power of these diode laser devices in order to enable performance improvements in full laser systems. In recent years, device technology has advanced to the point where the main limit to optical power is no longer device failure, but is instead power saturation due to various physical effects within the semiconductor device itself. For example, the combination of large optical cavity designs with advanced facet passivation means that facet failure is no longer the dominant limiting factor. Increases in the optical power therefore require firstly a clear identification of the limiting mechanisms, followed by design changes and material improvements to address these. Recent theoretical and experimental diagnostic studies at the Ferdinand-Braun-Institut have helped trace the saturation effects to three main effects: gain saturation, longitudinal-holeburning and current driven carrier leakage. Design changes based on these studies have enabled increases in the achievable emitted power density from broad area lasers. Recent experimental examples include ~100W from 100μm stripes under short-pulsed conditions, > 30W from 100μm stripes under quasi-continuous wave conditions and > 10W from 30μm stripes under continuous wave conditions. An overview of the results of the diagnostic studies performed at the FBH will be presented, and the design changes necessary to address the observed power saturation will be discussed.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
P. Crump, H. Wenzel, G. Erbert, G. Tränkle, "Progress in increasing the maximum achievable output power of broad area diode lasers", Proc. SPIE 8241, High-Power Diode Laser Technology and Applications X, 82410U (8 February 2012); doi: 10.1117/12.905250; https://doi.org/10.1117/12.905250
PROCEEDINGS
10 PAGES


SHARE
RELATED CONTENT

Progress in efficiency-optimized high-power diode lasers
Proceedings of SPIE (October 15 2013)
kW-class diode laser bars
Proceedings of SPIE (February 27 2017)
Advances in spatial and spectral brightness in 800 1100 nm...
Proceedings of SPIE (September 25 2009)
975 nm high power broad area diode lasers optimized for...
Proceedings of SPIE (February 17 2010)

Back to Top