Translator Disclaimer
9 March 2012 Performance of a prototype 32×32 pixel indirect x-ray imager based on a lateral selenium passive pixel sensor
Author Affiliations +
Abstract
An interface has been developed to capture frames taken by X-ray array imagers up to 64×64 pixels. An application specific integrated circuit (ASIC) designed solely for X-ray flat panel imaging readout circuitry, manufactured by FLIR® called Indigo (also known as ISC9717), was used as part of charge-amplifier block. An Altera Cyclone II FPGA is used to serve three purposes: Create pulses required for gate-driver block, Receive fast-stream data coming from the Indigo chip, and Send data through RS-232 protocol over a serial cable to a personal computer. Initial results for a 32×32 passive pixel sensor (PPS) with lateral amorphous Selenium metal-semiconductor-metal (MSM) photodetector were presented in [1]. This work focuses more on methods used to improve the images obtained from the array. Sharper images produced in sync with the light source are presented. In addition, insight into array readout circuitry and capturing a frame from an array is discussed.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Rasoul Keshavarzi, Kai Wang, Mohammad Y. Yazdandoost, Kyung-Wook Shin, Feng Chen, Shaikh Hasibul Majid, Shiva Abbaszadeh, and Karim S. Karim "Performance of a prototype 32×32 pixel indirect x-ray imager based on a lateral selenium passive pixel sensor", Proc. SPIE 8313, Medical Imaging 2012: Physics of Medical Imaging, 83135O (9 March 2012); https://doi.org/10.1117/12.912286
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
Back to Top