15 November 2011 Nonlinearity error correction of constant voltage power supply
Author Affiliations +
Proceedings Volume 8321, Seventh International Symposium on Precision Engineering Measurements and Instrumentation; 83212Y (2011) https://doi.org/10.1117/12.905203
Event: Seventh International Symposium on Precision Engineering Measurements and Instrumentation, 2011, Yunnan, China
Abstract
The paper introduces the basic principle of a kind of constant voltage power supply. A output circuit and a sampling feedback circuit are included in the power supply. There is a big problem between the two circuits, which is obvious nonlinearity error. Some simulation test is done in order to reduce the nonlinearity error. Two methods are presented according to the simulation result. One method is to add a self-adjusting circuit in the sampling feedback circuit, which can reduce the nonlinearity error through hardware. The other method is to add a special program in the soft so that the control signal is adjusted to be nonlinear according to the feedback signal, which can reduce the nonlinearity error through soft. The adjusting process is done repeatedly. The experiments show that the output of the constant voltage power supply ranges from 25 volts to 150 volts. Its error is reduced from original 43 volts to 0.6 volt and its hysteresis is improved greatly.
© (2011) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Y. B. Zhang, Y. B. Zhang, G. M. Liu, G. M. Liu, F. Ji, F. Ji, Z. Q. Wu, Z. Q. Wu, J. G. He, J. G. He, } "Nonlinearity error correction of constant voltage power supply", Proc. SPIE 8321, Seventh International Symposium on Precision Engineering Measurements and Instrumentation, 83212Y (15 November 2011); doi: 10.1117/12.905203; https://doi.org/10.1117/12.905203
PROCEEDINGS
7 PAGES


SHARE
Back to Top