15 November 2011 Pulsed eddy current systems for defect and geometrical profile measurement
Author Affiliations +
Proceedings Volume 8321, Seventh International Symposium on Precision Engineering Measurements and Instrumentation; 832143 (2011) https://doi.org/10.1117/12.912719
Event: Seventh International Symposium on Precision Engineering Measurements and Instrumentation, 2011, Yunnan, China
Abstract
Pulsed electromagnetic Non-destructive Evaluation (NDE) techniques can be used for defect detection and stress assessment. Currently there is no single technique which would have the capability to provide a comprehensive picture of these material changes, therefore the fusion of data from a number of different sensors is required for early failure prediction. In contrast to fusion techniques, signal feature separation can be applied for defect as well as lift-off measurement. Eddy current sensors can be applied for displacement (proximity) measurement as well as NDE for defect detection and material characterisation. For displacement measurement, one of research aims is to overcome measurement uncertainties due to material variation and in-homogeneity. After the introduction of pulsed eddy current (PEC) NDE, this work reports the separation of pulsed eddy current responses for surface profile and defect inspection. Experimental studies of pulsed eddy current for defects and surface profile measurement are reported.
© (2011) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Gui Yun Tian, Yunze He, Anthony Simm, "Pulsed eddy current systems for defect and geometrical profile measurement", Proc. SPIE 8321, Seventh International Symposium on Precision Engineering Measurements and Instrumentation, 832143 (15 November 2011); doi: 10.1117/12.912719; https://doi.org/10.1117/12.912719
PROCEEDINGS
7 PAGES


SHARE
Back to Top