8 March 2012 Factors that determine the optimum dose for sub-20nm resist systems: DUV, EUV, and e-beam options
Author Affiliations +
Abstract
As EUV and e-beam direct write (EBDW) technologies move closer to insertion into pilot production, questions regarding cost effectiveness take on increasing importance. One of the most critical questions is determining the optimum dose which balances the requirements for cost-effective throughput vs. imaging performance. To date most of the dose requirements have been dictated by the hardware side of the industry. The exposure tool manufacturers have a vested interest in specifying the fastest resists possible in order to maximize the throughput even if it comes at the expense of optimum resist performance. This is especially true for both EUV and EBDW where source power is severely limited. We will explore the cost-benefit tradeoffs which drive the equipment side of the industry, and show how these considerations lead to the current throughput and dose requirements for volume production tools. We will then show how the resulting low doses may lead to shot noise problems and a resulting penalty in resist performance. By comparison to the history of 248 nm DUV resist development we will illustrate how setting unrealistic initial targets for resist dose may lead to unacceptable tradeoffs in resist performance and subsequently long delays in the development of production worthy resists.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Moshe Preil, "Factors that determine the optimum dose for sub-20nm resist systems: DUV, EUV, and e-beam options", Proc. SPIE 8325, Advances in Resist Materials and Processing Technology XXIX, 832503 (8 March 2012); doi: 10.1117/12.920024; https://doi.org/10.1117/12.920024
PROCEEDINGS
9 PAGES


SHARE
Back to Top