Translator Disclaimer
20 March 2012 EUV resist processing with flash-lamp
Author Affiliations +
Abstract
The reduction of line width roughness (LWR) remains a difficult issue for very fine patterns obtained with extreme ultraviolet (EUV) lithography. Thus, the investigation of LWR-reduction from the viewpoint of resist processing has become necessary. Alternative bake processes, such as the flash-lamp (FL) has been proven feasible as for application in EUV resists. This work focuses on initial investigations for its use in post-development bake (post bake or PB). A polyhydroxystyrene-acryl hybrid EUV model resist was utilized and comparisons with 'no bake' and conventional hot-plate PB conditions were made. As a result, relatively improved LWR was obtained with FL PB with minimal effect on lithographic performance. Moreover, in the course of these experiments, two types of resist reflow mechanisms assumed to be the primary basis for the LWR improvement achieved, are discussed.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Julius Joseph Santillan, Koji Kaneyama, Akihiko Morita, Kazuhiko Fuse, Hiroki Kiyama, Masaya Asai, and Toshiro Itani "EUV resist processing with flash-lamp", Proc. SPIE 8325, Advances in Resist Materials and Processing Technology XXIX, 832513 (20 March 2012); https://doi.org/10.1117/12.916342
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT


Back to Top