Paper
14 May 2012 A LWIR hyperspectral imager using a Sagnac interferometer and cooled HgCdTe detector array
Paul G. Lucey, Mark Wood, Sarah T. Crites, Jason Akagi
Author Affiliations +
Abstract
LWIR hyperspectral imaging has a wide range of civil and military applications with its ability to sense chemical compositions at standoff ranges. Most recent implementations of this technology use spectrographs employing varying degrees of cryogenic cooling to reduce sensor self-emission that can severely limit sensitivity. We have taken an interferometric approach that promises to reduce the need for cooling while preserving high resolution. Reduced cooling has multiple benefits including faster system readiness from a power off state, lower mass, and potentially lower cost owing to lower system complexity. We coupled an uncooled Sagnac interferometer with a 256x320 mercury cadmium telluride array with an 11 micron cutoff to produce a spatial interferometric LWIR hyperspectral imaging system operating from 7.5 to 11 microns. The sensor was tested in ground-ground applications, and from a small aircraft producing spectral imagery including detection of gas emission from high vapor pressure liquids.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Paul G. Lucey, Mark Wood, Sarah T. Crites, and Jason Akagi "A LWIR hyperspectral imager using a Sagnac interferometer and cooled HgCdTe detector array", Proc. SPIE 8390, Algorithms and Technologies for Multispectral, Hyperspectral, and Ultraspectral Imagery XVIII, 83900Q (14 May 2012); https://doi.org/10.1117/12.918970
Lens.org Logo
CITATIONS
Cited by 17 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Sensors

Interferometers

Long wavelength infrared

Fourier transforms

Imaging systems

Mercury cadmium telluride

Back to Top