15 March 2013 Pulsed Nd:YAG laser fine spot welding for attachment of refractory mini-pins
Author Affiliations +
Abstract
Molybdenum (Mo) feedthrough pins (with a diameter of smaller than half of a millimeter) are commonly used for rechargeable batteries because of their inert nature and close CTE match with glass. Pure Mo has a very high melting temperature, and is not conducive to soldering. Due to the small geometry, the attachment of electrical conducting wire/ribbon to the pin is very challenging if conventional attachment methods were possible. Solid-state bonding by resistance welding is marginally feasible, but often results in moderate bond strength. In this work, fine spot welding using a pulsed Nd:YAG laser for the attachment of a conductive ribbon to a Mo pin is reported. The effect of the conductive ribbon materials was investigated. The weld condition was studied with the aim of determine the best set of laser processing parameters, including the angle of laser beam incidence, the laser power and the pulse duration. Weld strength testing on ribbon-pin weld structures was conducted. The laser fine spot welding resulted in a three times higher bond strength than resistance welding.
© (2013) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yaomin Lin, Yaomin Lin, Guangqiang Jiang, Guangqiang Jiang, } "Pulsed Nd:YAG laser fine spot welding for attachment of refractory mini-pins", Proc. SPIE 8608, Laser-based Micro- and Nanopackaging and Assembly VII, 86080P (15 March 2013); doi: 10.1117/12.2005842; https://doi.org/10.1117/12.2005842
PROCEEDINGS
11 PAGES


SHARE
Back to Top