Inspection and compositional analysis of sub-20 nm EUV mask blank defects by thin film decoration technique

V. Jindal; A. John; J. Harris-Jones; P. Kearney; A. Antohe; E. Stinzianni; F. Goodwin; T. Onoue

doi:10.1117/12.2012173

1 April 2013 Inspection and compositional analysis of sub-20 nm EUV mask blank defects by thin film decoration technique

V. Jindal, A. John, J. Harris-Jones, P. Kearney, A. Antohe, E. Stinzianni, F. Goodwin, T. Onoue

Author Affiliations +

Proceedings Volume 8679, Extreme Ultraviolet (EUV) Lithography IV; 86791O (2013) https://doi.org/10.1117/12.2012173
Event: SPIE Advanced Lithography, 2013, San Jose, California, United States

Abstract

EUVL requires a high yield of low-defect density reflective mask blanks, one of the top two critical technology gaps for the commercialization of this technology. One of the major sources of mask blank defects is the top of the substrate due to substrate quality, cleaning residue, and handling- or storage-induced defects. SEMATECH’s current inspection tool, the Lasertec 7360, can detect defects down to 37 nm on quartz substrates in dense scan mode. Defects below 40 nm on these substrate are difficult to detect, which challenges the quantification and characterization, and hence the determination of defect sources. SEMATECH developed a thin film decoration technique to quantify sub-40 nm defects and analyze composition to pinpoint defect sources. The technique involves oblique angle deposition in an ion beam deposition system, which decorates the particle. The decoration of particles is optimized by depositing enough thin film so that defects can be detected by the Lasertec7360 and yet keeping the film thin enough to employ several metrology techniques to efficiently analyze defect composition. The challenges involved with the metrology of such embedded defects and the impact of oblique angle deposition will be discussed. A theoretical model of defect decoration that can successfully simulate the thin film deposition on top of the defects will be provided. The effect of angle, deposition rate, and deposition time to quantify the decoration effect will also be presented.

Citation Download Citation

V. Jindal, A. John, J. Harris-Jones, P. Kearney, A. Antohe, E. Stinzianni, F. Goodwin, and T. Onoue "Inspection and compositional analysis of sub-20 nm EUV mask blank defects by thin film decoration technique", Proc. SPIE 8679, Extreme Ultraviolet (EUV) Lithography IV, 86791O (1 April 2013); https://doi.org/10.1117/12.2012173

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE