A maximum power point tracking algorithm for photovoltaic applications

Sudarshan R. Nelatury; Robert Gray

doi:10.1117/12.2016257

Translator Disclaimer

28 May 2013 A maximum power point tracking algorithm for photovoltaic applications

Proceedings Volume 8728, Energy Harvesting and Storage: Materials, Devices, and Applications IV; 87280I (2013) https://doi.org/10.1117/12.2016257
Event: SPIE Defense, Security, and Sensing, 2013, Baltimore, Maryland, United States

Abstract

The voltage and current characteristic of a photovoltaic (PV) cell is highly nonlinear and operating a PV cell for maximum power transfer has been a challenge for a long time. Several techniques have been proposed to estimate and track the maximum power point (MPP) in order to improve the overall efficiency of a PV panel. A strategic use of the mean value theorem permits obtaining an analytical expression for a point that lies in a close neighborhood of the true MPP. But hitherto, an exact solution in closed form for the MPP is not published. This problem can be formulated analytically as a constrained optimization, which can be solved using the Lagrange method. This method results in a system of simultaneous nonlinear equations. Solving them directly is quite difficult. However, we can employ a recursive algorithm to yield a reasonably good solution. In graphical terms, suppose the voltage current characteristic and the constant power contours are plotted on the same voltage current plane, the point of tangency between the device characteristic and the constant power contours is the sought for MPP. It is subject to change with the incident irradiation and temperature and hence the algorithm that attempts to maintain the MPP should be adaptive in nature and is supposed to have fast convergence and the least misadjustment. There are two parts in its implementation. First, one needs to estimate the MPP. The second task is to have a DC-DC converter to match the given load to the MPP thus obtained. Availability of power electronics circuits made it possible to design efficient converters. In this paper although we do not show the results from a real circuit, we use MATLAB to obtain the MPP and a buck-boost converter to match the load. Under varying conditions of load resistance and irradiance we demonstrate MPP tracking in case of a commercially available solar panel MSX-60. The power electronics circuit is simulated by PSIM software.

Citation Download Citation

Sudarshan R. Nelatury and Robert Gray "A maximum power point tracking algorithm for photovoltaic applications", Proc. SPIE 8728, Energy Harvesting and Storage: Materials, Devices, and Applications IV, 87280I (28 May 2013); https://doi.org/10.1117/12.2016257

ACCESS THE FULL ARTICLE