22 June 2013 Study on fabricating of micro-pyramid array by precision diamond turning
Author Affiliations +
Proceedings Volume 8769, International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013); 87691C (2013) https://doi.org/10.1117/12.2021119
Event: International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013), 2013, Singapore, Singapore
Abstract
As the demand for micro-patterned parts getting bigger, the need for molds with micro/nano scaled patterns to duplicate these parts effectively and economically is increasing ever so rapidly. Over the years, numerous attempts have been made to fabricate these molds using various approaches such as lithography, FIB, laser ablation, and precision diamond turning. Amongst these approaches, diamond turning is by far the most commonly used method to generate the micropatterned rollers for roll-to-roll fabricating of precision optical parts such as BEF and 3D films. However, micro-burrs are frequently produced during the micro-cutting process which not only makes the mold un-usable but also increases the cost of machining. Efforts have been made to study the burr formation process during the micro-cutting by FEM simulation, micro-scratching and diamond turning. Influences of the machining parameters such as rake angle, cutting edge radius, included angle and cutting speed on the burr formation were systematically investigated. Array of micropyramids with 90° apex angle, 40*40μm2 basal area and minimised burr were successfully produced on a OFCu roller of 270mm in diameter. The results showed that (i) tool rake angle, included angle and cutting edge radius have profound effect on burr formation and achievable surface finish, (ii) simulation can supply very useful information for setting the machining parameters to suppress the burr formation during micro-cutting process.
© (2013) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Choung-Lii Chao, Choung-Lii Chao, Wen-Chung Lin, Wen-Chung Lin, Wen-Chen Chou, Wen-Chen Chou, Jui-Ling Ko, Jui-Ling Ko, Kung-Jeng Ma, Kung-Jeng Ma, Chung-Woei Chao, Chung-Woei Chao, } "Study on fabricating of micro-pyramid array by precision diamond turning", Proc. SPIE 8769, International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013), 87691C (22 June 2013); doi: 10.1117/12.2021119; https://doi.org/10.1117/12.2021119
PROCEEDINGS
6 PAGES


SHARE
RELATED CONTENT

Surface finish and diamond tool wear when machining PMMA and...
Proceedings of SPIE (September 13 2018)
Wear Test Of A Preselected Diamond Tool
Proceedings of SPIE (February 12 1987)
Ultrasonic vibration turning of optical plastics
Proceedings of SPIE (August 01 1995)
Alpha Theta Machine
Proceedings of SPIE (December 15 1976)
Diamond Turning Large Optics
Proceedings of SPIE (December 15 1976)
Diamond Machining Of Metal & Plastic Optics
Proceedings of SPIE (December 15 1976)

Back to Top