22 June 2013 Design of a sensor for asphalt pavement pressure field measurements
Author Affiliations +
Proceedings Volume 8769, International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013); 876925 (2013) https://doi.org/10.1117/12.2016901
Event: International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013), 2013, Singapore, Singapore
Abstract
From the sensitivity of the FBG center wavelength changing with strain changes on the surface, the design of a FBG strain-based asphalt pavement pressure sensor is described by designing a special FBG asphalt box-film packaging structure. The compactness and simplicity of the device are achieved by using the corresponding package obtained from common available asphalt. Numerical analysis and experimental results show that the response of the sensor has good regularity for a wide range of travel (0MPa to 5.3312MPa). In the load range, the FBG center wavelength increases from 1548.264nm to 1548.346nm which shows a good correspondence with loads. Linearity, travel and sensitivity are experimentally determined by different packaging parameters. A design chart that includes the travel (0MPa to 5.3312MPa) and the sensitivity (15.3812pm/MPa) is finally proposed.
© (2013) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hongyue Liu, Hongyue Liu, Dakai Liang, Dakai Liang, Xiaolin Han, Xiaolin Han, Xiaogang Wang, Xiaogang Wang, } "Design of a sensor for asphalt pavement pressure field measurements", Proc. SPIE 8769, International Conference on Optics in Precision Engineering and Nanotechnology (icOPEN2013), 876925 (22 June 2013); doi: 10.1117/12.2016901; https://doi.org/10.1117/12.2016901
PROCEEDINGS
9 PAGES


SHARE
Back to Top