24 June 2014 Mercury cadmium telluride implanted junction profile measurement and depth control
Author Affiliations +
In this work, a novel junction profile measurement method is proposed. A serial of junctions were fabricated by B+ implantation. Then a beveled bar which was about 10mm long and several micrometers deep was formed by carefully controlled wet-etching. The remaining depth of n region changes from the full depth that is about 5.3mm after ion implantation to zero depending on its lateral position and the slope of the etching bar. Voltage-current and Laser Beam Induced Current (LBIC) measurements were applied to determine the HgCdTe junction edge. The LBIC signal orrectification characteristic indicates the existence of a PN junction. The junction depth is extracted from the position where the PN junction disappears and the slope of the etching bar. The junction depth of intrinsic doped HgCdTe was measured, which is about 2.4μm. A significant 0.4mm thick N-region was observed. Moreover, junction depths of samples annealed for different time were also investigated. By this method, it’s possible to measure the three dimensional profile of a planar PN junction.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Songmin Zhou, Songmin Zhou, Chun Lin, Chun Lin, Haibin Li, Haibin Li, Yanfeng Wei, Yanfeng Wei, Zhenhua Ye, Zhenhua Ye, Ruijun Ding, Ruijun Ding, Li He, Li He, "Mercury cadmium telluride implanted junction profile measurement and depth control", Proc. SPIE 9070, Infrared Technology and Applications XL, 907031 (24 June 2014); doi: 10.1117/12.2050100; https://doi.org/10.1117/12.2050100


New planar process for implementation of p on n HgCdTe...
Proceedings of SPIE (January 22 2003)
Doping control in HgCdTe epitaxial layers
Proceedings of SPIE (October 21 2003)
Post-annealing effect in HgCdTe photodiodes
Proceedings of SPIE (March 31 1993)

Back to Top