2 June 2014 Influence of spin manufacturing process on properties of the spun single mode fiber
Author Affiliations +
Proceedings Volume 9157, 23rd International Conference on Optical Fibre Sensors; 91572E (2014) https://doi.org/10.1117/12.2059593
Event: OFS2014 23rd International Conference on Optical Fiber Sensors, 2014, Santander, Spain
Abstract
Influence of spin manufacturing process on properties of the spun single mode fiber is investigated, a unidirectional spinning preform during the drawing process. The drawing speed constant is 1 m/min. The results show that pitch of the spun fiber exists; that mode field diameter (MFD) is obviously smaller; that cutoff wavelength and polarization mode dispersion (PMD) are decreased significantly, and then the loss is increased significantly when the spun fiber pitch is lower than 1.5 mm. It is very important for the fiber-optic gyroscope and fiber-optic current sensors to optimize spinning design to obtain relatively good spun fibers.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jian X. Wen, Jian X. Wen, Yan P. Wen, Yan P. Wen, Jie Wang, Jie Wang, Wen J. Liu, Wen J. Liu, Zhen Y. Chen, Zhen Y. Chen, Ting Y. Wang, Ting Y. Wang, Yan H. Luo, Yan H. Luo, Gang D. Peng, Gang D. Peng, } "Influence of spin manufacturing process on properties of the spun single mode fiber", Proc. SPIE 9157, 23rd International Conference on Optical Fibre Sensors, 91572E (2 June 2014); doi: 10.1117/12.2059593; https://doi.org/10.1117/12.2059593
PROCEEDINGS
4 PAGES


SHARE
Back to Top