Translator Disclaimer
25 September 2014 Building achromatic refractive beam shapers
Author Affiliations +
Achromatic beam shapers can provide beam shaping in a certain spectral band and are very important for various laser techniques, such as, applications based on ultra-short pulse lasers with pulse width <100 fs, confocal microscopy, multicolour holography, life sciences fluorescence techniques, where several lasers in spectrum 405-650 nm are used simultaneously, for example 405-650 nm. Conditions of energy re-distribution and zero wave aberration are strictly fulfilled in ordinary plano-aspheric lens pair beam shapers for a definite wavelength only. Hence, these beam shapers work efficiently in relatively narrow, few nm spectrum. To provide acceptable beam quality for refractive beam shaping over a wide spectrum, an achromatizing design condition should be added. Consequently, the typical beam shaper design contains more than two-lenses, to avoid any damaging and other undesirable effects the lenses of beam shaper should be air-spaced. We suggest a two-step method of designing the beam shaper: 1) achromatizing of each plano-aspheric lens using a buried achromatizing surface (“chromatic radius”), then each beam shaper component presents a cemented doublet lens, 2) “splitting” the cemented lenses and realizing air-spaced lens design using optical systems design software. This method allows for using an achromatic design principle during the first step of the design, and then, refining the design by using optimization software. We shall present examples of this design procedure for an achromatic Keplerian beam shaper and for the design of an achromatic Galilean type of beam shaper. Experimental results of operation of refractive beam shapers will be presented as well.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Alexander Laskin and David Shealy "Building achromatic refractive beam shapers", Proc. SPIE 9194, Laser Beam Shaping XV, 91940R (25 September 2014);


Theory of chromatic sensor for topography measurements
Proceedings of SPIE (April 12 2007)
Optical-Design Techniques For Polymer Optics
Proceedings of SPIE (September 16 1980)
Differential equation of the normal glass dispersion
Proceedings of SPIE (September 21 1998)
Design challenges for the 1990s
Proceedings of SPIE (January 01 1991)

Back to Top