23 September 2014 Polar format statistical image processing based fiber optic pressure sensors
Author Affiliations +
Abstract
This paper presents detailed study on the development of a fiber optic sensor system to design a pressure sensor with different sensor configurations. The sensor used in the experiments is based on modal power distribution (MPD) technique. MPD technique is spatial modulation of the modal power in multimode fibers. Stress measurements and CCD camera based techniques were investigated in this research. Differently from earlier MPD works, all of the data gathered from CCD camera are used instead of using some part of the data, the ring shaped pictures taken from the CCD camera converted to polar coordinates, and so stripe shaped pictures are obtained. Four different features are calculated from these converted pictures. R component of the center of mass in the polar form is the first feature. It is calculated because it was expected to decrease monotonically with respect to increasing applied pressure. Second and third features are ring thickness in polar form with taking brightness of each pixel into account and ring thickness in polar form without taking brightness of each pixel into account. These features are calculated to analyze the effect of each pixel’s brightness. It was expected for these two features that there will not be a big margin between them. Fourth feature is the ratio between third feature and first feature. A MATLAB code is written to correlate these features and applied force to the sensor. Various experiments conducted to analyze this correlation. Pictures are taken from CCD camera with 1 kg steps and from the written MATLAB code, graphics of each feature versus the applied force are generated. Experimental results showed that, the sensitivity of the proposed sensor is much higher than sensors that uses only some part of the collected data in earlier MPD studies. Furthermore, results are almost exactly the same that what was expected for the four proposed features. Results also showed that converting pictures to the polar form increases the sensitivity and reliability.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Muhammed Burak Alver, Muhammed Burak Alver, Onur Toker, Onur Toker, Kemal Fidanboylu, Kemal Fidanboylu, "Polar format statistical image processing based fiber optic pressure sensors", Proc. SPIE 9217, Applications of Digital Image Processing XXXVII, 92171F (23 September 2014); doi: 10.1117/12.2062699; https://doi.org/10.1117/12.2062699
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT


Back to Top