Paper
10 October 2014 Analysis of C-band spaceborne scatterometer thermal noise
Author Affiliations +
Abstract
A scatterometer is a radar designed to measure the backscattering coefficient of distributed targets. In order to compute the backscatter from the received power, the scatterometer measures also the thermal noise power. This noise signal is composed of two components, the receiver thermal noise and the viewed ground radiance. The first component is instrument dependent and hence independent of the target and viewing geometry. The second component is target and viewing geometry dependent, it is proportional to the ground target brightness temperature. In this paper the noise signal measured by C-band scatterometers on-board ERS-2 and Metop-A satellites is analyzed. It was found that the noise signal carries valuable geophysical information, which is worth to be exploited. It is shown that the noise signal varies spatially, temporally and with viewing geometry. Thus, different targets (ocean, sea ice, land) could be easily identified. A comparison was carried out between the scatterometer noise and AMSR-E radiometer brightness temperature and high correlation was found. The noise signal processing (mainly noise subtraction) is discussed, including the assessment of the Noise Equivalent Sigma Zero and the Signal-to-noise ratio. This analysis leads to a better understanding of the noise signal and its impact on the backscatter processing.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Anis Elyouncha and Xavier Neyt "Analysis of C-band spaceborne scatterometer thermal noise", Proc. SPIE 9240, Remote Sensing of the Ocean, Sea Ice, Coastal Waters, and Large Water Regions 2014, 924006 (10 October 2014); https://doi.org/10.1117/12.2068172
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Interference (communication)

Antennas

Signal to noise ratio

Receivers

Backscatter

Signal processing

Radiometry

Back to Top