13 November 2014 Influence of both angle and position error of pentaprism on accuracy of pentaprism scanning system
Author Affiliations +
Abstract
Pentaprism scanning system has been widely used in the measurement of large flat and wavefront, based on its property that the deviated beam will have no motion in the pitch direction. But the manufacturing and position errors of pentaprisms will bring error to the measurement and so a good error analysis method is indispensable. In this paper, we propose a new method of building mathematic models of pentaprism and through which the size and angle errors of a pentaprism can be put into the model as parameters. 4 size parameters are selected to determine the size and 11 angle parameters are selected to determine the angles of a pentaprism. Yaw, Roll and Pitch are used to describe the position error of a pentaprism and an autocollimator. A pentaprism scanning system of wavefront test is simulated by ray tracing using matlab. We design a method of separating the constant from the measurement results which will improve the measurement accuracy and analyze the system error by Monte Carlo method. This method is simple, rapid, accurate and convenient for computer programming.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kun Xu, Sen Han, Qiyuan Zhang, Quanying Wu, "Influence of both angle and position error of pentaprism on accuracy of pentaprism scanning system", Proc. SPIE 9276, Optical Metrology and Inspection for Industrial Applications III, 92761O (13 November 2014); doi: 10.1117/12.2071533; https://doi.org/10.1117/12.2071533
PROCEEDINGS
15 PAGES


SHARE
Back to Top