2 September 2014 Active edge control in the precessions polishing process for manufacturing large mirror segments
Author Affiliations +
Proceedings Volume 9280, 7th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Large Mirrors and Telescopes; 928007 (2014) https://doi.org/10.1117/12.2069790
Event: 7th International Symposium on Advanced Optical Manufacturing and Testing Technologies (AOMATT 2014), 2014, Harbin, China
Abstract
The segmentation of the primary mirror is the only promising solution for building the next generation of ground telescopes. However, manufacturing segmented mirrors presents its own challenges. The edge mis-figure impacts directly on the telescope’s scientific output. The ‘Edge effect’ significantly dominates the polishing precision. Therefore, the edge control is regarded as one of the most difficult technical issues in the segment production that needs to be addressed urgently. This paper reports an active edge control technique for the mirror segments fabrication using the Precession's polishing technique. The strategy in this technique requires that the large spot be selected on the bulk area for fast polishing, and the small spot is used for edge figuring. This can be performed by tool lift and optimizing the dell time to compensate for non-uniform material removal at the edge zone. This requires accurate and stable edge tool influence functions. To obtain the full tool influence function at the edge, we have demonstrated in previous work a novel hybrid-measurement method which uses both simultaneous phase interferometry and profilometry. In this paper, the edge effect under ‘Bonnet tool’ polishing is investigated. The pressure distribution is analyzed by means of finite element analysis (FEA). According to the ‘Preston’ equation, the shape of the edge tool influence functions is predicted. With this help, the multiple process parameters at the edge zone are optimized. This is demonstrated on a 200mm crosscorners hexagonal part with a result of PV less than 200nm for entire surface.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hongyu Li, Wei Zhang, David Walker, Gouyo Yu, "Active edge control in the precessions polishing process for manufacturing large mirror segments", Proc. SPIE 9280, 7th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Large Mirrors and Telescopes, 928007 (2 September 2014); doi: 10.1117/12.2069790; https://doi.org/10.1117/12.2069790
PROCEEDINGS
7 PAGES


SHARE
Back to Top