1 April 2015 Strain-dependent characterization of electrode and polymer network of electrically activated polymer actuators
Author Affiliations +
Abstract
Fecal incontinence describes the involuntary loss of bowel content and affects about 45 % of retirement home residents and overall more than 12 % of the adult population. Artificial sphincter implants for treating incontinence are currently based on mechanical systems with failure rates resulting in revision after three to five years. To overcome this drawback, artificial muscle sphincters based on bio-mimetic electro-active polymer (EAP) actuators are under development. Such implants require polymer films that are nanometer-thin, allowing actuation below 24 V, and electrodes that are stretchable, remaining conductive at strains of about 10 %. Strain-dependent resistivity measurements reveal an enhanced conductivity of 10 nm compared to 30 nm sputtered Au on silicone for strains higher than 5 %. Thus, strain-dependent morphology characterization with optical microscopy and atomic force microscopy could demonstrate these phenomena. Cantilever bending measurements are utilized to determine elastic/viscoelastic properties of the EAP films as well as their long-term actuation behavior. Controlling these properties enables the adjustment of growth parameters of nanometer-thin EAP actuators.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tino Töpper, Tino Töpper, Bekim Osmani, Bekim Osmani, Florian M. Weiss, Florian M. Weiss, Carla Winterhalter, Carla Winterhalter, Fabian Wohlfender, Fabian Wohlfender, Vanessa Leung, Vanessa Leung, Bert Müller, Bert Müller, } "Strain-dependent characterization of electrode and polymer network of electrically activated polymer actuators", Proc. SPIE 9430, Electroactive Polymer Actuators and Devices (EAPAD) 2015, 94300B (1 April 2015); doi: 10.1117/12.2084595; https://doi.org/10.1117/12.2084595
PROCEEDINGS
11 PAGES


SHARE
Back to Top