Paper
7 January 2015 Quantification of synthetic lens surface characteristics by an optical measurement system as stylus instrument
Patrick Schäfer, Christine Wünsche, Rolf Rascher
Author Affiliations +
Proceedings Volume 9442, Optics and Measurement Conference 2014; 944219 (2015) https://doi.org/10.1117/12.2176184
Event: Optics and Measurement Conference 2014, 2014, Liberec, Czech Republic
Abstract
A measurement system to monitor the turning tool achieves a reduction in production rejects by decreasing the delay time between tool wear detection and quality control of the surface, which usually takes place after the time-intensive polishing process. In highly automated production of lucent synthetic lenses the standardized polishing process turns out to be inefficient if there is an insufficient surface quality caused by outrunning tool wear limits of the undergone turning process. The possibility to indicate the tool’s wear will be demonstrated by checking the surface characteristics of synthetic lenses. For that research an experimental measurement setup is shown. This optical measurement system detects the surface’s roughness, which is indicative of tool wear.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Patrick Schäfer, Christine Wünsche, and Rolf Rascher "Quantification of synthetic lens surface characteristics by an optical measurement system as stylus instrument", Proc. SPIE 9442, Optics and Measurement Conference 2014, 944219 (7 January 2015); https://doi.org/10.1117/12.2176184
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Optical testing

Radium

Polishing

Surface finishing

Distance measurement

Reliability

Back to Top