7 January 2015 Cooling options for high-average-power laser mirrors
Author Affiliations +
Proceedings Volume 9442, Optics and Measurement Conference 2014; 94421G (2015) https://doi.org/10.1117/12.2086590
Event: Optics and Measurement Conference 2014, 2014, Liberec, Czech Republic
Thermally-induced deformations of steering mirrors reflecting 100 J/10 Hz laser pulses in vacuum have been analyzed. This deformation is caused by the thermal stress arisen due to parasitic absorption of 1 kW square-shaped flat-top laser beam in the dielectric multi-layer structure. Deformation depends on amount of absorbed power and geometry of the mirror as well as on the heat removal scheme. In our calculations, the following percentages of absorption of the incident power have been used: 1%, 0.5% and 0.1%. The absorbed power has been considered to be much higher than that expected in reality to assess the worst case scenario. Rectangular and circular mirrors made of zerodur (low thermal expansion glass) were considered for these simulations. The effect of coating layers on induced deformations has been neglected. Induced deformation of the mirror surface can significantly degrade the quality of the laser beam in the beam delivery system. Therefore, the proper design of the cooling scheme for the mirror in order to minimize the deformations is needed. Three possible cooling schemes of the mirror have been investigated. The first one takes advantage of a radiation cooling of the mirror and a copper heatsink fixed to the rear face of the mirror, the second scheme is based on additional heat conduction provided by flexible copper wires connected to the mirror holder, and the last scheme combines two above mentioned methods.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
D. Vojna, D. Vojna, O. Slezak, O. Slezak, A. Lucianetti, A. Lucianetti, T. Mocek, T. Mocek, "Cooling options for high-average-power laser mirrors", Proc. SPIE 9442, Optics and Measurement Conference 2014, 94421G (7 January 2015); doi: 10.1117/12.2086590; https://doi.org/10.1117/12.2086590


Possibilities of using a 1070 nm laser in machining of...
Proceedings of SPIE (October 31 2012)
High-speed laser cutting of thin metal sheets
Proceedings of SPIE (September 06 1994)
Ti:Al2O3 laser pumped by a copper vapor laser
Proceedings of SPIE (December 27 1999)
New Japanese AVLIS program
Proceedings of SPIE (May 27 1993)

Back to Top