17 July 2015 The design and fabrication of common optical components lithography lens
Author Affiliations +
Proceedings Volume 9524, International Conference on Optical and Photonic Engineering (icOPEN 2015); 95240P (2015) https://doi.org/10.1117/12.2186932
Event: International Conference on Optical and Photonic Engineering (icOPEN2015), 2015, Singapore, Singapore
Abstract
The design and fabrication of common optical components lithography Lens has been carried out for a 1 to 1 stepper. The specification of lens is fulfilled the 3-D lithography system as 2 micron in resolution for 1 inch x 2.8 inches system. The lens has been sophistically designed by dual path in a triplet to reduce the number of components. A single aspherical surface has been applied to reduce the aberration to diffraction limit in lens. The well-made shapes of lens have been suggested. Then, the fabrication of lens has been in the process. Finally, the optical axis of tolerance optical mechanical mountings for lens system in assembly has been analyzed, and valuable for assembly and fabrication.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jiun-Woei Huang, Jiun-Woei Huang, } "The design and fabrication of common optical components lithography lens", Proc. SPIE 9524, International Conference on Optical and Photonic Engineering (icOPEN 2015), 95240P (17 July 2015); doi: 10.1117/12.2186932; https://doi.org/10.1117/12.2186932
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT

Design and simulation of large field plate lithography lens
Proceedings of SPIE (October 24 2016)
A new kind of three anastigmatic mirrors system
Proceedings of SPIE (February 09 2005)
Controlling surface figure errors of optical components
Proceedings of SPIE (September 08 2010)
Specification Of Scan Lenses
Proceedings of SPIE (July 13 1986)
Low-cost high-volume lens using diffractive technology
Proceedings of SPIE (October 31 1997)

Back to Top