Translator Disclaimer
Paper
11 September 2015 Analysis of deformations of thin wall parts in machining
Author Affiliations +
Proceedings Volume 9662, Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments 2015; 96624L (2015) https://doi.org/10.1117/12.2205850
Event: XXXVI Symposium on Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments (Wilga 2015), 2015, Wilga, Poland
Abstract
The article presents a study on deformation of thin-walled components during milling. In the practical part, the test position consisting of conventional milling machines, high-speed camera and piezoelectric dynamometer was prepared. Milling operations performed on samples prepared of ST3S steel. Cutting parameters for each sample were the same, the way of mounting the samples in a holder constituted the difference. The tests were made for conventional and climbing milling. During the tests, deformation of samples was recorded with the high-speed camera. Moreover, the cutting forces were also recorded. In the second part of the article, the work in NX application was described. Geometric models of samples and material model were built, and simulation of deformation of the samples was performed. A comparison of the deformation results obtained from the laboratory tests and simulations constitutes a summary of the article.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ł. Ślusarczyk "Analysis of deformations of thin wall parts in machining", Proc. SPIE 9662, Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments 2015, 96624L (11 September 2015); https://doi.org/10.1117/12.2205850
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
Back to Top