8 September 2016 Control x-ray deformable mirrors with few measurements
Author Affiliations +
After years of development from a concept to early experimental stage, X-ray Deformable Mirrors (XDMs) are used in many synchrotron/free-electron laser facilities as a standard x-ray optics tool. XDM is becoming an integral part of the present and future large x-ray and EUV projects and will be essential in exploiting the full potential of the new sources currently under construction. The main objective of using XDMs is to correct wavefront errors or to enable variable focus beam sizes at the sample. Due to the coupling among the N actuators of a DM, it is usually necessary to perform a calibration or training process to drive the DM into the target shape. Commonly, in order to optimize the actuators settings to minimize slope/height errors, an initial measurement need to be collected, with all actuators set to 0, and then either N or 2N measurements are necessary learn each actuator behavior sequentially. In total, it means that N+1 or 2N+1 scans are required to perform this learning process. When the actuators number N is important and the actuator response or the necessary metrology is slow then this learning process can be time consuming. In this work, we present a fast and accurate method to drive an x-ray active bimorph mirror to a target shape with only 3 or 4 measurements. Instead of sequentially measuring and calculating the influence functions of all actuators and then predicting the voltages needed for any desired shape, the metrology data are directly used to “guide” the mirror from its current status towards the particular target slope/height via iterative compensations. The feedback for the iteration process is the discrepancy in curvature calculated by using B-spline fitting of the measured height/slope data. In this paper, the feasibility of this simple and effective approach is demonstrated with experiments.
Conference Presentation
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Lei Huang, Lei Huang, Junpeng Xue, Junpeng Xue, Mourad Idir, Mourad Idir, } "Control x-ray deformable mirrors with few measurements", Proc. SPIE 9965, Adaptive X-Ray Optics IV, 99650H (8 September 2016); doi: 10.1117/12.2237808; https://doi.org/10.1117/12.2237808


Adaptive x-ray optics development at AOA-Xinetics
Proceedings of SPIE (May 02 2013)
New scheme to control x-ray deformable mirrors
Proceedings of SPIE (October 24 2016)
New Design Of Mirror Bending Block
Proceedings of SPIE (May 02 1982)
Adaptive x-ray optics development at AOA-Xinetics
Proceedings of SPIE (October 14 2012)

Back to Top