13 October 2017 Noncontact holographic detection for photoacoustic tomography
Author Affiliations +
J. of Biomedical Optics, 22(10), 106007 (2017). doi:10.1117/1.JBO.22.10.106007
A holographic method for high-speed, noncontact photoacoustic tomography is introduced and evaluated. Relative changes of the object’s topography, induced by the impact of thermoelastic pressure waves, were determined at nanometer sensitivity without physical contact. The object’s surface was illuminated with nanosecond laser pulses and imaged with a high-speed CMOS camera. From two interferograms measured before and after excitation of the acoustic wave, surface displacement was calculated and then used as the basis for a tomographic reconstruction of the initial pressure caused by optical absorption. The holographic detection scheme enables variable sampling rates of the photoacoustic signal of up to 50 MHz. The total acquisition times for complete volumes with 230 MVoxel is far below 1 s. Measurements of silicone and porcine skin tissue phantoms with embedded artificial absorbers, which served as a model for human subcutaneous vascular networks, were possible. Three-dimensional reconstructions of the absorbing structures show details with a diameter of 310    μ m up to a depth of 2.5 mm. Theoretical limitations and the experimental sensitivity, as well as the potential for in vivo imaging depending on the detection repetition rate, are analyzed and discussed.
© 2017 Society of Photo-Optical Instrumentation Engineers (SPIE)
Christian Buj, Michael Münter, Benedikt Schmarbeck, Jens Horstmann, Gereon Hüttmann, Ralf Brinkmann, "Noncontact holographic detection for photoacoustic tomography," Journal of Biomedical Optics 22(10), 106007 (13 October 2017). https://doi.org/10.1117/1.JBO.22.10.106007 Submission: Received 31 May 2017; Accepted 22 September 2017
Submission: Received 31 May 2017; Accepted 22 September 2017

Back to Top