7 February 2018 Determination and verification of the x-ray spectrum of a CT scanner
Author Affiliations +
The accuracy of Monte Carlo (MC) simulations in estimating the computed tomography radiation dose is highly dependent on the proprietary x-ray source information. To address this, this study develops a method to precisely estimate the x-ray spectrum and bowtie (BT) filter thickness of the x-ray source based on physical measurements and calculations. The static x-ray source of the CT localizer radiograph was assessed to measure the total filtration at the isocenter for the x-ray spectrum characterization and the BT profile (air-kerma values as a function of fan angle). With these values, the utilized BT filter in the localizer radiograph was assessed by integrating the measured air kerma in a full 360-deg cycle. The consistency observed between the integrated BT filter profiles and the directly measured profiles pointed to the similarity in the utilized BT filter in terms of thickness and material between the static and rotating x-ray geometries. Subsequently, the measured air kerma was used to calculate the BT filter thickness and was verified using MC simulations by comparing the calculated and measured air-kerma values, where a very good agreement was observed. This would allow a more accurate computed tomography simulation and facilitate the estimation of the dose delivered to the patients.
© 2018 Society of Photo-Optical Instrumentation Engineers (SPIE)
Ahmad Ibrahim Hassan, Ahmad Ibrahim Hassan, Martin Skalej, Martin Skalej, Helmut Schlattl, Helmut Schlattl, Christoph Hoeschen, Christoph Hoeschen, } "Determination and verification of the x-ray spectrum of a CT scanner," Journal of Medical Imaging 5(1), 013506 (7 February 2018). https://doi.org/10.1117/1.JMI.5.1.013506 . Submission: Received: 24 March 2017; Accepted: 10 January 2018
Received: 24 March 2017; Accepted: 10 January 2018; Published: 7 February 2018

Back to Top