1 July 2011 Materials challenges for sub-20-nm lithography
Author Affiliations +
Abstract
We discuss the future of resist materials for sub-20-nm lithography and believe that polymer-bound PAG-based resists will be used to 16-nm node. There has been enough progress in resolution and sensitivity to justify the use of these materials. Polymer-bound PAG resists have shown that the principal demerit of acid diffusion can be overcome through attachment of the PAG anion to the lithographic polymer. Since the introduction of this chemically amplified resist approach, we have seen steady improvement in resolution, sensitivity, and LWR. We have also seen improvement in OOB response, outgassing, and pattern collapse. There is no doubt that continuous improvement is still required for these resist systems. We believe that increasing the overall resist quantum yield for acid generation substantially improves the shot-noise problem thereby leading to faster high-resolution resist materials. Using a 0.30-NA extreme ultraviolet tool with dipole, we can achieve 22-nm hp resolution, with a 12-mJ dose and a 4.2-nm LWR.
© (2011) Society of Photo-Optical Instrumentation Engineers (SPIE)
James W. Thackeray, James W. Thackeray, } "Materials challenges for sub-20-nm lithography," Journal of Micro/Nanolithography, MEMS, and MOEMS 10(3), 033009 (1 July 2011). https://doi.org/10.1117/1.3616067 . Submission:
JOURNAL ARTICLE
9 PAGES


SHARE
Back to Top