6 February 2013 Applications of advanced metrology techniques for the characterization of extreme ultraviolet mask blank defects
Author Affiliations +
Abstract
Characterization of defects and their sources is essential for developing mitigation solutions to support the production of defect-free extreme ultraviolet (EUV) mask blanks. The characterization of sub-100-nm defects pose challenges to the conventional metrology techniques, such as atomic force microscopy and scanning electron microscopy, limiting mitigation of nanoscale defects. SEMATECH’s Mask Blank Development Center houses advanced metrology capabilities that include transmission electron microscopy (TEM) and Auger electron spectroscopy (AES) to address these shortcomings. Scanning TEM was used to study the disruption of the Mo/Si multilayer of phase defects and to perform elemental analysis with energy dispersive x-ray spectroscopy that has supported projects including substrate smoothing activities, deposition simulation development, and defect printability studies. The Auger instrument was used to create elemental maps for defect identification and to characterize the ion beam deposition tool. Using advanced metrology, mitigation of small defects is being realized, yielding mask blanks with defect counts as low as eight defects at 50-nm sensitivity (Lasertec M7360 SiO2 sphere equivalent) measured over the quality area of 132×132 mm2 . The issues with the metrology of increasingly small EUV mask blank defects will be outlined, and comprehensive defect characterization results using TEM and AES will be presented.
© 2013 Society of Photo-Optical Instrumentation Engineers (SPIE)
Jenah Harris-Jones, Jenah Harris-Jones, Emilio Stinzianni, Emilio Stinzianni, Chihcheng Lin, Chihcheng Lin, Vibhu Jindal, Vibhu Jindal, Ranganath Teki, Ranganath Teki, Hyuk Joo Kwon, Hyuk Joo Kwon, } "Applications of advanced metrology techniques for the characterization of extreme ultraviolet mask blank defects," Journal of Micro/Nanolithography, MEMS, and MOEMS 12(1), 013007 (6 February 2013). https://doi.org/10.1117/1.JMM.12.1.013007 . Submission:
JOURNAL ARTICLE
7 PAGES


SHARE
RELATED CONTENT


Back to Top