10 May 2013 Design, simulation, and fabrication of a MEMS-based air amplifier for electrospray ionization
Author Affiliations +
Recent developments in electrospray ionization mass spectrometry (ESI-MS) show that air amplifiers can be utilized to significantly enhance droplet desolvation and to focus gas-phase ions when provided between an electrospray (ES) source and the mass spectrometer (MS). However, these devices are bulky and expensive, which may be a factor prohibiting their broader utilization. We have developed a simple but effective method based on Bernoulli’s principle, the Coanda effect and MEMS processing to focus electrosprayed droplets and liberated gas-phase ions. We demonstrate a computer simulation and fabrication process for a micromachined air amplifier. The simulation results are used to optimize the geometry and to meet performance requirements. The optimized results then provide a design guideline for the device’s fabrication. The air amplifier is formed from two bonded polydimethylsiloxane (PDMS) casts. Each PDMS cast is fabricated through a molding process using a micromachined two-layer SU-8 mold. Experimental results show a 30-fold improvement in the ES current for certain operation conditions while the air amplifier is incorporated in the nano-electrospray ionization (nano-ESI) process. Compared with traditional air amplifiers, the micro-electro-mechanical systems (MEMS) based air amplifier provides good performance while keeping the fabrication process simple and cost effective.
© 2013 Society of Photo-Optical Instrumentation Engineers (SPIE)
Petr Jurčíček, Petr Jurčíček, Helin Zou, Helin Zou, Shuai Gao, Shuai Gao, } "Design, simulation, and fabrication of a MEMS-based air amplifier for electrospray ionization," Journal of Micro/Nanolithography, MEMS, and MOEMS 12(2), 023006 (10 May 2013). https://doi.org/10.1117/1.JMM.12.2.023006 . Submission:


X-Ray Laser Microscopy
Proceedings of SPIE (November 26 1989)
Advances in laser driven soft x-ray lasers at LOA
Proceedings of SPIE (October 04 2011)
An ICP etch model based on time multiplexed deep etching
Proceedings of SPIE (February 06 2006)

Back to Top